I probably should've taken some photos of the etching process, but here are both spars and all ribs for both left and right elevators all sanded and etched ready to prime.
And a close-up as the ribs can't seen very well in the previous image...
Trim tab push rod and attach bracket...
Trim Tab Access Reinforcement Doubler...
Thought I'd put the skins here to dry. I know, not the best place where there's a chance to stand on them. I moved them straight after the photo.
Here's a better place for them...
Counter-sinking the trailing edges was a little fidgety as you need to ensure the face being presented to counter-sink is perpendicular to it. I simply used a similar section flipped 180 degrees probably seen better two images down...
Before and after counter-sinking...
No, I can count. The numbers written on the parts are actually the part numbers.
No comments:
Post a Comment