I know, these look the same as the others. Yep, it's also a good record of the quality of the rivets - can't praise the pneumatic squeezer enough. It's awesome.
This is No.6 HS-912 hinge
Once the squeezer's set, squeeze away - they all end up the same!
The rear of inside left elevator hinges...
No.7 HS-912 (left to right)
No.8 HS-912
The rear of the inboard right elevator (HS-912) hinges
No.9 HS-912
No.10 HS-912
Rear of outside right elevators hinges...
I had to purchase a new torque wrench to install the Inboard Hinge Bracket Assembly brackets
(HS-0911; VA146).
The nuts are required to be torqued to 28in-pnds.
I know, the following photo was taken at only 26in-pnds...
As you can see below, some scotch tape and red marker highlight what I shouldn't be riveting....not just yet anyway.
HS-902(front) Front Spar clecoed
HS-902(rear) Front Spar clecoed
No comments:
Post a Comment