All nut plates on the left inspection panel complete.
I actually found the rivet gun and bucking bar easier in this case as I had plenty of places around the rivet to brace the bucking bar. That and turning the rivet gun pressure down a little made it much easier to modulate and create a better set rivet.
The screws aren't quite flush. Not critical right now, but I do want them sitting more flush than they. I'll most likely just make the correct size holes in the perspex panels when I make them.
This photo shows them raised just a little.
Ah, that's right - page 10-14 would explain it...
Looks like I have more parts to buy..........next order.
No comments:
Post a Comment